Inhaltsverzeichnis
Werbung
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician
for help.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End user
must follow the specific operating instructions for satisfying
RF exposure compliance. This transmitter must not be co-
located or operating in conjunction with any other antenna
or transmitter.
The portable device is designed to meet the requirements
for exposure to radio waves established by the Federal
Communications Commission (USA). These requirements
set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value reported under this standard
during product certification for use when properly worn on
the body.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
46
Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions: (1)
This device may not cause interference.(2)This device must
accept any interference, including interference that may
cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes
:(1)L'appareil ne doit pas produire de brouillage; (2)L'appareil
doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with ISED radiation exposure
limits set forth for an uncontrolled environment. End user
must follow the specific operating instructions for satisfying
RF exposure compliance. This transmitter must not be co-
located or operating in conjunction with any other antenna
or transmitter.The portable device is designed to meet the
requirements for exposure to radio waves established by
the ISED.
Cet équipement est conforme aux limites d'exposition
aux rayonnements ISED établies pour un environnement
non contrôlé. L'utilisateur final doit suivre les instructions
spécifiques pour satisfaire les normes. Cet émetteur ne
doit pas être co-implanté ou fonctionner en conjonction
avec toute autre antenne ou transmetteur. Le dispositif
portatif est conçu pour répondre aux exigences d'exposition
aux ondes radio établie par le développement énergétique
DURABLE.
These requirements set a SAR limit of 1.6 W/kg averaged
over one gram of tissue. The highest SAR value reported
under this standard during product certification for use
when properly worn on the body.
Ces exigences un SAR limite de 1,6 W/kg en moyenne
pour un gramme de tissu. La valeur SAR la plus élevée
signalée en vertu de cette norme lors de la certification
de produit à utiliser lorsqu'il est correctement porté sur le
corps.
Werbung
Inhaltsverzeichnis
