Adjust The Brightness ( 1-100%) On The Luminaire; Set Colour Mode (H 0-360°) On The Luminaire; Set The Colour Saturation (P 1-100) On The Lamp - Starter Spectar Rgb Led Ring 3.2 Kit Gebrauchsanleitung

1. Slightly open the clamp (15a) of the holder (15).
2. Turn the bracket (15b) to the appropriate position and tighten the
bracket lock (15a) again.
3. If necessary, loosen the holder fixing screw (15c), clamp the
smartphone and tighten the screw until the smartphone is held.
Do not tighten the screw too much, so that the smartphone is not
damaged!
4. To remove the smartphone, hold it with one hand and loosen the holder
fixing screw (15c) with the other hand.
7.8 Adjust the brightness (
1. Switch on the luminaire as described in the chapter 6.
2. Turn the rotary knob (5) to the right or left until the desired brightness is
reached.
→ The selected % value is shown in the middle line of the display (6).
7.9 Set colour mode (H 0-360°) on the luminaire
1. Switch on the luminaire as described in the chapter 6.
2. Press the function knob (7) until the colour (H) is shown in the bottom
line of the display and release the knob.
3. Turn the function knob (7) to the right or left until the colour
corresponds to your idea.
→ The corresponding colour in ° is shown in the bottom line of the
display (28).

7.10 Set the colour saturation (p 1-100) on the lamp.

1. Switch on the luminaire as described in the chapter 6.
2. Press the function knob (7) until the saturation (S) is shown in the bottom
line of the display and release the knob.
3. Turn the function knob (7) to the right or left until the saturation
corresponds to your idea.
→ The corresponding saturation is shown in the bottom line of the
display (29).
40
1-100%) on the luminaire.