Pivot Luminaire; Mounting / Dismounting The Hot Shoe Holder; Mounting / Dismounting The Tablet / Smartphone Holder On The Hot Shoe Mount; Clamp The Tablet In The Holder - Starter Spectar Rgb Led Ring 3.2 Kit Gebrauchsanleitung

7.3 Pivot luminaire

1. Slightly loosen the fixing screw of the svivel joint (11) gently.
Hold the luminaire while doing this.
2. Swivel the luminaire to the desired position.
3. Tighten the swivel joint of the bracket (11) again.

7.4 Mounting / dismounting the hot shoe holder

1. Slide the hot shoe bracket (14) into one of the hot shoe connections (16)
on the back for mounting from the front.
2. Pull the hot shoe bracket (14) backwards out of the hot shoe
connection (16) for disassembly.
7.5 Mounting / dismounting the tablet / smartphone holder on the
hot shoe mount.
NOTE - The tablet holder has
mounting.
1. Screw the ¼ inch thread of the bracket (8/15) onto the ¼ inch screw of
the hot shoe bracket (14) until they are firmly connected and nothing
wobbles.
2. Unscrew the ¼ inch thread of the bracket (8/15) from the ¼ inch screw of
the hot shoe bracket (14) and remove the bracket (8/15).

7.6 Clamp the tablet in the holder

The tablet holder is suitable for all common tablets from 11-19 cm wide.
It can be used horizontally or vertically due to the two sliding brackets.
1. Pull up the sliding clamp (8a) of the bracket (8).
2. Position the tablet between the two brackets and carefully move the
clamping bracket (8a) down again until the holder has gripped and the
tablet is held securely.
3. To remove the tablet, hold it with one hand and pull up the clamp (8a)
with the other hand.

7.7 Clamp the smartphone in the holder

The holder is suitable for all common smartphones 5.5-9.5 cm wide.
2× ¼ inch threads for horizontal and vertical
EN
39