Power Supply Via Rechargeable Battery - Starter Spectar Rgb Led Ring 3.2 Kit Gebrauchsanleitung

NOTE - Only operate the luminaire if the connection values match the
local power supply.
5. To switch on, set the on/off switch (20) to the position. [I].

6.4 Power supply via rechargeable battery

WARNING
Risk of explosion or injury due to improperly used batteries.
Batteries can leak or explode if handled improperly.
■ Only use rechargeable batteries that are specified in these
instructions for use, see technical data.
■ Do not place batteries in a fire or expose them to direct heat.
■ Remove batteries if the luminaire is not to be used for a long time or
if the batteries are discharged.
■ If battery fluid comes into contact with skin or clothing, rinse
immediately with fresh water.
■ Do not charge the batteries in the luminaire. Use a suitable charger
for this purpose.
■ Do not charge batteries unattended.
■ Disconnect the charger from the mains as soon as charging is
complete.
1. Switch off the luminaire. To do this, move the on/off switch (20)
to the position [0].
2. Remove the plug of the power supply (12) from the socket (18)
on the back of the lamp.
3. Push two sufficiently charged NP-F batteries from the front into the
two battery docks (19) of the light.
→ A clear click indicates that they are securely in place.
4. To switch on, tilt the on/off switch (20) to the position [I].
36