Technical Specifications - Elkron Ir600Fc/Rf Installations-, Programmier- Und Gebrauchsanleitun

3. Check the RSSI value on the control unit.
4. Proceed with the installation.
Installation
Installation guidelines
The detector was designed to be mounted on a flat surface or in a corner by means of the angle bracket using the fixing

screws and the anchor bolts provided.
The base has hole arrangements where the plastic is thinner for mounting. The two arrangements are used to fix on a

surface. While the three holes are used to fix the angle bracket.
It is advisable to install the detector as shown below:

In the point in which a possible intruder would normally cross the field of vision of the detector.
-
At a height of 1.9 - 2 m from the ground for optimal performance.
-
In a corner to have the widest view possible.

In a point in which the field of vision is not obstructed, e.g. by curtains, ornaments etc.

Restrictions
Do not position the detector pointing directly towards a door protected by a door contact, because the wireless signals of

the door contact and of the detector could be transmitted in the same instant and cancel themselves out.
Do not install the detector so that it is completely exposed to direct sunlight.

Avoid installing the detector in areas in which devices which could cause sudden changes of temperature in the detection

area are present, such as air conditioning units, radiators etc.
Avoid the presence of large size obstacles in the detection area.

Do not point it directly towards sources of heat, such as stoves or boilers, or over radiators.

Avoid moving objects in the detection area, such as curtains, hanging objects etc.

Detector installation
Surface installation:

1. Loosen the fixing screw and gently lift the cover, taking care not to lose the rubber button
over the tamper switch.
2. Perforate the hole arrangements on the base for fixing on a surface.
3. Using the two holes as template, drill the holes corresponding to the
surface.
4. Insert the anchor bolts if the device is fixed to plaster or bricks.
5. Screw the base into the anchor bolts.
6. Reposition the cover onto the base.
Corner installation:

1. Perforate the two arrangements for holes on the corner bracket.
2. Using the two holes as template, drill the holes corresponding to the surface.
3. Insert the anchor bolts if the device is fixed to plaster or bricks.
4. Screw the bracket into the anchor bolts.
5. Fasten the detector to the bracket.

Technical specifications

Power supply: 2 alkaline batteries AA 1.5 V

Battery life: 4 years (typical value, can vary according to use)

Infrared range: max 12 m

Radio frequency band: 868,600-868.700MHz

Maximum radio power transmitted: 9,69dBm

Camera: VGA CMOS with 102° horizontal angle

Working temperature range: -10°C – +45°C

Dimensions: 105mm x 70mm x 40.0mm

Weight: 200g

Compliant with EN 50131 Degree 2, ClassⅡ

Hereby, URMET S.p.A. declares that the radio equipment type: INDOOR INFRARED DETECTOR WITH CAMERA IR600FC/RF is
in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: www.elkron.com.
DS80IR9E-001
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hole provisions for
fixing on surface (x 2)
Arrangement for holes for
corner fixing (x 2)
7