Panasonic CZ-RCC5 Bedienungsanleitung Seite 6

If connection is unsuccessful, either one of the three pop-up
window will appear:
i) Connection with both units failed
ii) Connection with main unit failed
only
iii) Connection with sub unit failed only
Please ensure that both CNT cables are connected properly at
indoor unit and wired remote controller according to CNT cable
Installation Manual. After that, repeat Steps 2.1 to 2.5. (Contact
an authorised dealer if problem persists).
2.6 After connection is successful, press
window. After returning to Operation screen, The Duty Rotation
icon
throughout the Duty Rotation operation.
MODE
AUTO
25
The operation setting for Duty Rotation mode will follow the
previous setting saved before operation OFF.
• After Duty Rotation is successfully set, sub unit remote
controller will be disabled.
6
should appear on the top left corner. This icon will appear
11:35,Mon
SET TEMP. FAN SPEED
AUTO
.0
FLAP
°
C
AUTO
Rotation 11:35,Mon
Disabled due to
ON
connection with
both units failed!
OFF
Close
Select Confirm
Rotation 11:35,Mon
Disabled due to
ON
connection with
Main unit failed!
OFF
Close
Select Confirm
Rotation 11:35,Mon
Disabled due to
ON
connection with
Sub unit failed!
OFF
Close
Select Confirm
to close the pop-up