Sony A7R V Einführungsanleitung Seite 11

How to turn off wireless network
functions (Wi-Fi, etc.) temporarily
When you board an airplane, etc., you
can turn off all wireless network functions
temporarily using [Airplane Mode].
Power Cord
Multiple power cords may be supplied
with this equipment. Use the appropriate
one that matches your country/region.
For the customers in the UK, Ireland,
Malta, Cyprus and Saudi Arabia
Use the power cord (A).
For safety reasons, the power cord (B) is
not intended for above countries/regions
and shall therefore not be used there.
For the customers in other EU
countries/regions
Use the power cord (B).
(A)
For Customers in the U.S.A.
and Canada
The available scientific evidence does
not show that any health problems
are associated with using low power
wireless devices. There is no proof,
however, that these low power wireless
devices are absolutely safe. Low power
Wireless devices emit low levels of radio
frequency energy (RF) in the microwave
range while being used. Whereas high
levels of RF can produce health effects
(by heating tissue), exposure of low-level
RF that does not produce heating effects
causes no known adverse health effects.
Many studies of low-level RF exposures
have not found any biological effects.
Some studies have suggested that some
biological effects might occur, but such
findings have not been confirmed by
additional research. This equipment has
been tested and found to comply with
FCC/ISED radiation exposure limits set
forth for an uncontrolled environment
and meets the FCC radio frequency (RF)
Exposure Guidelines and RSS-102 of the
ISED radio frequency (RF) Exposure rules.
(B)
For Customers in the U.S.A.
For question regarding your product or
for the Sony Service Center nearest you,
call 1-800-222-SONY (7669) .
Supplier's Declaration of Conformity
Trade Name : SONY
Model : WW282174
Responsible Party : Sony Electronics
Inc.
Address : 16535 Via Esprillo, San Diego,
CA 92127 U.S.A.
Telephone Number : 858-942-2230
Important note on use of 5 GHz wireless
LAN
Compliance with FCC requirement
15.407(c)
Data transmission is always initiated
by software, which is the passed down
through the MAC, through the digital and
analog baseband, and finally to the RF
chip. Several special packets are initiated
by the MAC. These are the only ways
the digital baseband portion will turn on
the RF transmitter, which it then turns
off at the end of the packet. Therefore,
the transmitter will be on only while one
of the aforementioned packets is being
transmitted. In other words, this device
automatically discontinue transmission in
case of either absence of information to
transmit or operational failure.
Frequency Tolerance: ±20 ppm
For Customers in Canada
5 150-5 350 MHz band is restricted to
indoor operation only.
High-power radars are allocated as
primary users (i.e. priority users) of the
bands 5 250-5 350 MHz and 5 650-
5 850 MHz and that these radars could
cause interference and/or damage to
LE-LAN devices.
EN
EN
11