Installation Instructions - Comedes BTR 50 Bedienungsanleitung

Leave the appliance in its final, upright position for at least 24 hours before starting
it up for the first time.
Always operate the appliance in an upright position and do not tilt it during
operation.

Installation Instructions

Operate the device only in rooms with at least 20m².
floor space
• Remove all adhesive tapes that were used for transport securing.
• Check that the device is standing securely on firm, level and dry ground.
• Never install the unit where it may be exposed to the following conditions:
Heat sources, such as radiators, heat registers, stoves or other products that
o
generate heat
In an area where oil or water can be splashed.
o
Direct solar radiation
o
Mechanical vibrations or shocks
o
Excessive dust exposure
o
Lack of ventilation, e.g. in a cupboard or bookshelf
o
Uneven surface
o
• Make sure that the power outlet is equipped with an RCD (ground fault circuit interrupter).
If you are not sure whether this is the case, you can ask your electrician or use
a personal protection plug (available at a hardware store).
• To save power and avoid potential hazards, disconnect the unit when not in use.
• Keep at least 50cm distance around the device to walls and objects. Make sure that the air
outlet is free and that there are no curtains or textiles above it.
min. 50cm
min. 50cm
EN-10
min. 50cm
min. 50cm
www.comedes.com