Comedes BTR 50 Bedienungsanleitung Seite 36

If this is not possible, the room can be preheated with another electric heater. However, the
dehumidifier must not be located in this room.
The safety and operating instructions in this manual must be followed under all circumstances.
Drying in case of problems with condensation
Condensation moisture usually occurs in cellars when moist air enters the cellar in summer and
condenses on the cold cellar walls. We recommend to dehumidify the cellar room by room in
continuous operation at first. Let the appliance run continuously at first until you notice that
the amount of water you drain from the tank every day becomes less. Now place the device in
the next room. Once you have dried all rooms, we recommend selecting a central installation
location and operating the unit in automatic mode. This type of dehumidification is more
energy-efficient than if you dehumidify immediately in automatic mode, as the appliance then
switches off and on very frequently.
Drying in case of construction defects or water damage
In the case of construction defects and water damage, the cause should first be eliminated.
The rooms can then be dried with condensation dryers such as the BTR 50. The dehumidifier is
operated in continuous operation. The ambient temperature should be at least 20°C (no more
than 27°C).
Caution: Only heat the room with water-bearing heating units such as underfloor heating and
permanently installed radiators.
If this is not possible, the room can be preheated with another electric heater. However, the
dehumidifier must not be located in this room.
The safety and operating instructions in this manual must be followed under all circumstances.
Please note that, depending on the construction defect, drying of the insulation layer may also
be necessary
can be. This must be carried out by a specialist company.
Recommended air humidity for rooms
Basically this depends on the ambient temperature. The higher the temperature of the room,
the lower the relative humidity should be set, otherwise mould growth in the room is favoured.
The pleasant air humidity ranges from 35% to 65% relative humidity, depending on the
ambient temperature.
The following diagram gives an indication of which humidity is optimal at which ambient
temperatures.
EN-15
www.comedes.com