Pairing Procedure - SISTEMATICA Classic CNTR 4 Benutzerhandbuch

PAIRING PROCEDURE

PAIRING is a necessary operation only if you need to replace the receiver
or want to use it with a handheld device other than the one it was paired
with at the time of purchase. For the most recent devices of the CLASSIC
line it is an AUTOMATIC PAIRING that takes place without having to open
the products:
1. As soon as the CONTROLLER is powered up, the YELLOW LED of the device
starts to flash slowly.
2. Within 5 seconds, simultaneously press any three keys on the handheld
device (except STOP) until the YELLOW LED flashes three times.
TUTORIAL PAIRING
Upon request, it is also possible to combine multiple handhelds
with the same controller.
QRCode
For systems that are not updated to the latest version, here below the
MANUAL PAIRING procedure:
1. Remove power from the controller.
2. Open it by unscrewing the two screws next to the connector (CNTR8 and
CNTR20) or the four screws on the bottom (CNTR32).
3. Locate and press the blue coding button on the electronic board.
4. Power up the controller by keeping the coding button pressed for 3-4 sec.;
the green LED on the receiver board starts flashing, then release the code
button.
5. Simultaneously press any 3 buttons on the handheld within 15 seconds of
switching on (until the green LED starts flashing).
6. At this point the handheld is coded with the controller; the verification of
the correct coding of the system is carried out by testing the movements
of the system.
7. Close the receiver by tightening the two screws (CNTR8 and CNTR20) or
the four screws (CNTR32) removed in step 2.
BLUE
CODING BUTTON
85