Care Instructions - Hesperide TINAEI 165468B Bedienungsanleitung

CARE INSTRUCTIONS

1/ Your product
Properties
The frame and the ribs are made of bamboo, a robust and moisture-resistant material.
The crank is made of epoxy steel (steel coated with a protective paint against rust).
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different assembled
elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is carried out
individually, before assembly. These metallic elements cannot be free from appearance irregularities coming both
from the surface treatment process and assembly operations. The final appearance of the product is therefore
directly linked to these possible irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to notice that some
threads are not cut after the break point of the seam. There is no risk of the seam becoming undone. Cut this
thread with a simple pair of scissors.
Size of the cloth
The size indicated always corresponds to the size flat of the cloth. The useful size is slightly less, due to the angle
given to the cloth by the parasol.
2/ Precautions for use
We cannot guarantee the good behavior of this product under difficult atmospheric conditions.
We recommend closing the umbrella during strong winds, thunderstorms, hailstorms or heavy rain. In these
conditions, it is recommended not to be under or near the parasol.
After each significant bad weather we invite you to check the general condition and the solidity of the structure
before use. Attention, danger of overturning in the event of a gust of wind.
Fold the parasol in case of wind and strap it.
It is recommended not to leave an open umbrella unattended.
The accumulation of water and / or dead leaves on the canvas contributes to its degradation and to that of the
structure: make sure to clean it regularly and to eliminate any pockets of water.
Do not hang products on the frame.
It is necessary to fix the parasol in a stable, weighted base and on a flat surface.
We do not recommend mounting a light fixture or other heat source on the structure in contact with or near the
fabric.
Watch out for knives and other sharp objects being handled nearby. Also watch out for cigarette burns and other
sources of heat.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an alteration of
the colours and the state of the surface, the mechanical functions and tightening of the screwed elements.
Tightening
The assembly parts of your product become loose over time. Think of tightening them regularly.
Exposure to UV rays
Over time, you can see a discoloration of the materials exposed to UV rays (textiles, paint, plastics), a
phenomenon also due to the rays of the sun as well as those of the moon. This evolution of colours exposed to
external elements is normal and concerns in particular bright colours.