schnitzer Vario Gebrauchsanweisung Seite 7

mill
This Vario mill is suited for grinding all types of grain,
all sizes of wheat and smaller ones as well as corn (no
popcorn). Oleiferous seeds should not be ground
alone! Oilseeds can be ground fine, if you mix, e.g.
500 g wheat and one teaspoon oilseeds.
Using dry grain, the milling capacity is as follows:
110 g/min in the case of fine adjustment, 300 g/min in
the case of coarse adjustment.
Grinding material overview
Can be grinded with an electric mill
YES
wheat | rye | barley | kamut | einkorn
✓
emmer | millet | brown millet
oat | naked oat
spelt | green spelt
brown rice | white rice (no parboiled rice) ✓
corn (no popcorn)
buckwheat | amaranth,
canihua | quinoa
✓
lentils
soybeans | chickpeas
lupines | husked green peas
mung beans | white beans
pumpkin seeds | sunflower seeds
poppy seeds
linseeds | sesame | chia
psyllium (plantain seed) ✓
coffee
nuts
anise | fennel | cloves | caraway
coriander
✓
pepper black and white
pepper red
mustard seeds
The intense spice aromas can be absorbed by the millstones.
After grinding spices, it is recommended to grind rice.
NO LIMITED, PLEASE PAY ATTENTION
please avoid finest grinding setting, a rough setting is
✓
sufficient for fine flour
please avoid finest grinding setting, a rough setting is
✓
sufficient for fine flour
✓ grind step by step, depending on the size of the grain
grind step by step, depending on the size of the grain
✓
✓
grind step by step, depending on the size of the grain
✓
✓
✓ mix 1 tablespoon of the seeds with 500 g grain
grind step by step. Warning: the stones could absorb the
✓
coffee flavor
✓
please avoid finest grinding setting, a rough setting is
✓
sufficient for fine flour
✓
✓ grind only in a coarse setting
flaker
You can flake nearly all kinds of grain with your Vario
mill with the exception of corn and similar big grains.
Please note the following recommendations:
Oat is the most commonly used grain and can be
effortlessly flaked without any further treatment owing
to its soft edges.
For getting nicer flakes (that stick better together), you
should moisten the wished quantity in a sieve with
water and dry it for 5 hours.
Please check our website for more information.
operation
•
Place the Vario mill on a solid and flat tabletop so that it has a firm standing and then insert the plug
into the socket. The mill is now ready to be started.
•
Press in button on funnel so that throughput opening is locked. Turn funnel to your wished position.
•
If button shows to
–
front > you have chosen the grinding setting
–
>
back you have chosen the flaking setting
•
Fill the required quantity of grain into the wooden or metal funnel.
•
Operate the on/off switch on the left-hand side of the mill.
You can see the milling or flaking adjustment by the
pictograms indicated on switch:
–
centre position > off
–
pressed in on the upper side >
–
pressed in on the lower side >
•
Pull the button towards you so that the slide is open.
Therefore the cereals will fall into grinding or flaking
chamber. Now the cereals are ground or flaked.
•
If there are still cereals in funnel, after grinding
your required quantity, just close the slide.
The grains which are still in the mill should be ground.
flaking
grinding