INSTALLATION
Installation
f Using a screwdriver, screw the threaded rod into the small
threaded hole in the tap.
f Make sure that the lower O-ring is inserted into the tap.
Property damage
!
f Tighten the connection hoses until finger-tight only.
Do not use pliers or a spanner.
f Take care not to twist the hoses.
f Screw the connection hoses into the threaded holes in the
tap unit until they are finger-tight. When doing so, observe
the markings on the tap and connection hose.
f Insert the tap into the hole from above.
f Secure the tap onto the threaded rod from below with the
soft profile washer, U-shaped pressure washer and hexagon
nut.
f Remove the transport lock from the drain outlet.
f Insert the drain outlet with the gasket into the drain from
above.
f Push the profile gasket onto the drain outlet from below.
f Screw the drain funnel onto the drain outlet from below.
www.stiebel-eltron.com
1
2
4
1
4
1 Two-part pull rod
2 Screw cap
3 Centring washer
MAE-K | MAE-W | WST-W | TWS-W | WUT-K |
3 4
5
6
7
27