Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation Guide
Step 6: Adjust the focal length
01.
Ensure that the tested object is placed
flat before focusing (including the test
platform and the material itself)
02.
Put down the focus pole so that the
focus pole just contact to the carved
object to determine the focal length
03.
Tighten the handle to lock the laser
04.
Take back the fixed focus pole
05.
Fix focus completed
06.
Set engraving parameters refer to the parameter table
12
Werbung
Inhaltsverzeichnis
