Factory Defaults - Zodiac E30 iQ Einbau- Und Betriebsanleitung

5. Press to enter speed.
MODE
SET
NOTE
More than one (1) minute of inactivity will confirm selection automatically. If ON/OFF is
pressed before entering a time, all changes will be lost.
6. Press or to change the priming time by one (1) minute increments. Range is 0 - 30 minutes.
MODE
SET
7. Press to enter time. Display automatically returns to Settings with speed flashing.
MODE
SET
MODE
SET
NOTE
More than one (1) minute of inactivity will confirm selection automatically. If ON/OFF is
pressed before entering a time, all changes will be lost.
8. Press to enter Settings menu.
MODE
SET
• Wi-Fi
1. Press down and
MODE
SET
MODE
SET
• Restore
1. Press to enter Settings menu.
MODE
SET
2. Press or until "rSET" displays.
MODE
SET
3. Press to restore to the factory defaults. Display will turn Off.
MODE
MODE
SET
SET

Factory Defaults

• Low Speed: 50%
• Medium Speed: 75%
• High Speed: 100%
• Priming Speed: 100%
• Priming Time: 0 minutes
• Speed in MANUAL Mode: High Speed
• AUTO/Schedule: OFF
• Schedule Settings: All speeds are LOW; T-Start and T-Stop are "00:00"
• Wi-Fi-Bluetooth: OFF
5. MAINTENANCE
•
To avoid risk of property damage, severe personal injury or death, verify that all
power is turned off before starting this procedure.
•
Inspect the pump debris basket for debris by looking through the clear pump lid.
Keep the basket clean to improve the performance of the pump. See Figure 7.
•
A misaligned basket will cause the lid to be improperly seated, allowing an air
leak, which could result in pump damage. Clean the pump basket.
• Clean the pump basket.
– Turn off the power to the pump. If the pump is located below the water level, close the isolation
Installation and general maintenance manual
for an extended time to enter Pair Mode.
- VARIABLE SPEED PUMP 37