PIEPS PRO BT Bedienungsanleitung Seite 17

CONFORMITY
EUROPE
Hereby, Pieps GmbH declares that the radio equipment type PIEPS PRO BT/POWDER BT is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is avail-
able at the following internet address: www.pieps.com/conformity
USA/CANADA
Manufacturer: Pieps GmbH | Type/Model: PRO BT/POWDER BT
FCC ID: REMDSP04 | IC: 7262A-DSP04
USA: FCC Notice, Cautions and Statement
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) This device must accept any interfer-
ence received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm-
ful interference in a residual installation. This equipment generates, uses and can radiate frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or trans-
mitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF
energy that are deemed to comply without testing of specific absorption ratio (SAR).
Canada: IC Notice
This device complies with Industry Canada's licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference; and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment
and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of
RF energy that are deemed to comply without testing of specific absorption ratio (SAR).
17