PIEPS PRO BT Bedienungsanleitung Seite 13

STRUCTURE DISPLAY
(2A) Direction indication
(2B) Distance indication
(2C) Transmit symbol
(2D) Battery capacity/type
(2E) MARK (marking possible)
(2F) Active transmitting antenna
(2G) Number of burials (1-3)
(2H) Number of burials (4 or more)
CARRYING SYSTEM
PIEPS recommends using the included carrying system (3A). In order to protect the beacon's
display, carry the beacon with its display facing inwards (3B). The transmit control LED (1G) is
visible in the pouch´s window (3C). The included hand-loop (3D) is intended for training purpose.
SWITCHING ON | SELF-CHECK | SEND MODE
Move the slider lock (1C) to the left and the slider (1B) upwards into the position SEARCH. Then
release the slider lock (1C) and move the slider (1B) downwards, until it locks in the position
SEND.
The display shows firmware version, battery capacity, self-check progress (4A), self-check
result (4B), group check countdown (4C) and finally the send display with the active transmit-
ting antenna (4D).
The device is now in send mode, the transmit control LED (1G) is blinking.
SEND  SEARCH
Move the slider lock (1C) to the left and the slider (1B) upwards in the position SEARCH.
SEARCH  SEND
Move the slider (1B) downwards, until it locks in the position SEND.
SEARCH MODE | SEARCH STRATEGY
SIGNAL SEARCH (5A)
Walk the search strip width in the search area quickly. The recommended search strip width for
the PIEPS PRO BT/POWDER BT is 60 m. The display shows "no signal" (5A1).
(2J) Transmitter marked
(2K) Bluetooth® active
(2L) Inclinometer mode*
(2M) TX600 mode*
(2N) SCAN mode*
(2P) Analog mode*
(2Q) Meter symbol for SCAN /analog mode*
* PIEPS PRO BT only
13