Villager MBC 33 E Gebrauchsanweisungen Seite 61

Villager
TROUBLESHOOTING
Before performing any maintenance or cleaning work, always turn off the engine and wait
until the cutter has come to a standstill.
1) The engine will not start or will not keep running
--- Reassemble the nylon cutter.
--- Check that weather there is no fuel or be used out.
--- Incorrect starting procedure-- Follow the instructions
--- Dirty spark plug or incorrect distance between the electrodes- Check the spark plug
--- Air filter clogged- Clean and/or replace the filter
--- Carburation problems- Contact your Dealer
2) The engine starts but is lacking in power
--Have nylon spool replaced (customer service centre)
-- Air filter clogged-- Clean and/or replace the filter
-- Carburation problems- Contact your Dealer
3) The engine runs irregularly and lacks in power when revved
-- Dirty spark plug or incorrect distance between the electrodes- Check the spark plug
-- Carburation problems-- Contact your Dealer
4) The engine makes too much smoke
-- Incorrect composition of the fuel mixture- Prepare the fuel mixture according to the instructions.
-- Carburation problems- Contact your Dealer
5) The cutting device must not move when the engine is running idle
-- Incorrect carburetion regulation - Contact your Dealer
6) The machine starts to vibrate abnormally
-Damaged or loose parts- Stop the machine and disconnect the spark plug cable Inspect for
damage. Check for and tighten any loose parts. Have all checks, repair work and replacements
carried out by a specialized Centre only.
7) If the temperature of machines is too high:
---insure the machines have rest at regular time.
Faults which cannot be rectified with the aid of this table may be rectified by a specialist company
only (customer service centre).
29
MBC 33 E (GB)