Villager MBC 33 E Gebrauchsanweisungen Seite 50

Villager
NOTE
For longest chain life, let new or replacement chain loops soak in oil overnight before
installation
1. Using the small end of the plug wrench, remove the sprockets cover nut(turn counter clockwise to
remove) and remove the chain wheel cover.
2. Place the guide bar over the guide bar adjustment stud on the cutting head assembly. Align the chain
tensioning pin with screwdriver:
-Remove the chain wheel cover (Item J) by undoing the fastening nut (Item I). Lay the chain (Item F)
as shown into the groove which runs around the cutter bar (Item E). Note the alignment of the chain
teeth. Insert the cutter bar into the mount at the gear unit. Place the chain round the chain wheel
(Item H). Make sure that the teeth of the chain engage securely in the chain wheel. The cutter bar
must be hooked into the chain tensioning bolt (Item G).
3. Install the chain wheel cover (Item J) over the bar stud. Using finger-pressure only install the
sprocket cover nut (Item I).
CAUTION！
Failure to align the guide bar and chain
tensioning pin can cause serious damage to
the sprocket cover, guide bar, chain
tensioning pin and cutting head assembly.
18
MBC 33 E (GB)