Villager MBC 33 E Gebrauchsanweisungen Seite 40

Villager
ASSEMBLY
When assembling this machine, please follow the instructions for assembly printed.
1. Mounting the rod:
- Pull out the stop pin (1) and push the lower part of the rod (2) right down until the stop
pin (1) clicks into the hole (3) in the rod. This is easier to do if you rotate the bottom of
the rod (2) slightly in both directions. The pin (1) is in place when it is completely lodged
in the hole.
-Once inserted, tighten the knob (4) securely.
2. Assemble the handle on the machine.
-Fit the sleeve (2) and low part (3) with guard, placing the pin (3a) in one of the three holes on
the drive tube.
-Fit the front handgrip (4) by using the screws (5).
-Before tightening the screws (4), align the handgrip correctly with respect to the drive tube.
-Fully tighten the screws (4).
3. Assemble the safe guard.
Fix the transmission with hex key and wrench enclosed as standard accessories for tightening
the nuts with the safe guard.
-The guard is fixed to the angle transmission by two screws
8
MBC 33 E (GB)