Rollei HD-1 Bedienungsanleitung Seite 46

Using the Wall Mount
46
CAUTION!
Prior to drilling check that no supply pipes are concealed in the wall!
− First mark the holes to be drilled [A], by holding the base of the wall fixing
against the desired place of installation . When installing on stone or
concrete surfaces use a 6 mm masonry drill .
− After drilling the holes insert the supplied wall plugs into the holes so that
they are flush with the surface .
− Next secure the stand using screws from the assembly kit.
− Next place the wildlife camera onto the tripod bolt [B] and partly secure
the camera (approx . 3 turns) . Turn the camera to the desired alignment and
secure with the counter screws [C] .
Prior to installing the Wildlife Camera on the wall mounting a
memory card or batteries should be inserted or the power supply
should be connected . The camera should also be switched to „On" .
Don´t try to mount the camera facing the rising or setting sun . If
mounting to a feeder or in a dusty environment , be sure to clean the
camera lens and the PIR sensor regularly .
Periodically check the mounting of the camera to make sure it hasn't
come loose . Check the batteries frequently to ensure they are still
providing power to the camera .
ENGLISH