Connections And Controls; Optional Accessories; Initial Setup - Sharp SUMOBOX CP-LS100 Bedienungsanleitung

10

Connections and controls

(Refer to A on page 2).
1. Volume Control: Adjust the volume of the connected input.
2. Treble Control: Adjust the high tones of the connected instrument
or microphone (CH1 and CH2 only).
3. Bass Control: Adjust the low tones of the connected instrument or
microphone (CH1 and CH2 only).
4. Reverb Control: Adjust how much reverb is applied to the
connected instrument or microphone (CH1 and CH2 only).
5. Input Type: Use the switch to select the input type for CH1 and CH2.
The LED indicates the selected device type.
6. XLR/TRS Combi: Connect instruments, guitars (TRS) and
Microphones (XLR)
Note: The XLR input does not output Phantom power.
7. USB Out (DC 5V 1000mA): Allows mobile devices to be charged.
Note: This is not intended for USB flash disks to play audio files.
8. Ducking Control: Turns ducking feature ON/OFF.
When ON, CH3 audio will be suppressed by CH1 and CH2 audio. Also
controls Indoor/Outdoor mode.
Blue (solid)
Blue (fast flashes x4)
Blue (slow flashes x2)
9. Bluetooth / Duo Mode: Turns ON/OFF Bluetooth and Duo Mode
functions. See section "Bluetooth and Duo Mode" for more
information".
SumoBox is ready to pair to a Bluetooth
Blue (flashing)
device.
Blue (solid)
SumoBox is connected to a Bluetooth device.
SumoBox is looking for another SumoBox
Yellow (flashing)
to pair with.
SumoBox is paired to another SumoBox and
is the secondary unit.
Yellow (solid)
When connected, the Bluetooth LED on
the primary unit will flash until a Bluetooth
device is connected.
10. 3.5 mm AUX In: Connect an audio device via a 3.5mm cable. When
an AUX device is first connected it will autoswitch from any active
Bluetooth connection.
11. Power Switch: Turns the SumoBox ON / OFF.
Blue (solid)
Red (solid)
Red (blinking)
12. Speaker Link IN / OUT: Connect additional SumoBoxes.
13. Power In: Connect to the mains power via the supplied power lead.
AC 200-240V ~50/60Hz
Note: Ensure you use the correct power cable for your region.
14. USB Charging Port (5V 1000mA): Allows mobile devices to be
charged.
15. Battery Status LED: Press the button to see the battery Status.
Ducking on
Indoor mode
Outdoor mode
Power on
Standby
Low battery (battery powered only)
16. Battery clip: Secures the battery pack in place. Push the clip to the
right to allow the battery pack to be removed.
17. DC 18V Input: Allows charging of the battery when not installed in
the SumoBox.
Note: External charger sold separately with CP-LSBP1.
18. Connection to SumoBox
Box contents
• CP-LS100 SumoBox
• Power cable
• Battery pack
• Corner protectors (x8)
• Hex driver tool
• User documentation

Optional Accessories:

• Battery Pack & Charger (CP-LSPB1)
Sold separately.
Initial set up
Before first use, it is recommended to charge the battery pack for a
minimum of four hours (or until fully charged).
Anytime the battery is installed and the SumoBox is connected to mains
power, the battery will charge.
10 % – 25 %
26 % – 50 %
51 % – 75 %
76 % – 100 %
Turning on the SumoBox
If using SumoBox with instruments:
1. Connect any instruments/microphones to the desired channels.
2. Switch any powered instruments on and ensure they are not sending
any signals.
3. Turn on the SumoBox via the power switch.
The power LED will turn solid blue to indicate the speaker is on.
If using SumoBox only with Bluetooth
If only using Bluetooth connections, turn the SumoBox on to start
connecting.
NOTE:
When turning off the SumoBox, perform these steps in the reverse order.