Machine Specification; Technical Data - Sthor 73473 Bedienungsanleitung

MACHINE SPECIFICATION

Sharpener allows for sharpening the drill bit made of steel. Sharpening drill bits for drilling in metal or universal drills is also pos-
sible. Sharpener is not intended for sharpening drill bits with a blades made of ceramic, wood drills, pen drills, drill bits, crown bits
and drill bits of the shape edge diff erent than the drills for steel and universal drills. It is also possible to sharpen knives, scissors,
and hatchets and choppers, provided that all of the above mentioned products are made of steel. Sharpener does not allow for
sharpening the ceramic materials. Correct, reliable, and safe operation of the tool is dependent on proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damage or injuries caused by failure to comply with safety regulations and instructions of this manual, the supplier is not
responsible.
PRODUCT EQUIPMENT
The product is supplied in a complete state and requires no assembly. The machine is not equipped with drills.

TECHNICAL DATA

Parameter
Catalogue No
Mains voltage
Mains frequency
Rated power
Rated revs
Diameter of the drill bit
Point angle of the drill bit
Insulation class
Degree of protection
Noilse level
- accustic pressure L ± K
pA pA
- accustic power L ± K
wA wA
Weight
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
increases the risk of electric shock.
In the case of working outside closed rooms, use extension cords intended for work outside closed rooms. The use of an
extension cord adapted for outdoor use reduces the risk of electric shock.
When using a power tool in a humid environment is unavoidable as a protection against supply voltage use a residual
current device (RCD). The use of RCD reduces the risk of electric shock.
O R I G I N A L
EN
Unit
[V a.c.]
[Hz]
[W]
[min -1 ]
[mm]
[degrees]
[dB (A)]
[dB (A)]
[kg]
I N S T R U C T I O N S
Value
73473
230 - 240
50
150
5500
3 – 13
118
II
IP20
80,0 ± 3,0
93,0 ± 3,0
1.62 kg.
11