Installation Instructions; Height Adjustment; Wheel Lock - Lionelo Aurora Bedienungsanleitung

Installation instructions

1.
Slide the legs of the cot (9, fig. A) into the corresponding place on the frame
(fig. 1). Correct installation will signal a click.
2.
Slide the stabilization bar (6, fig. A) into the guides on both sides of the cot
frame (fig. 2).
3.
Slide the carrycot base (5, fig. A) into the guides on both sides of the cot
frame (fig. 3).
4.
Pass the harness (7, fig. A) through the corresponding holes in the cot cover
(A, fig. 4) and then insert the stabilization plate (2, fig. A). Tighten the straps
by fastening over the top of the plate (B, Fig. 4).
5.
Insert the mattress (fig. 5). The line in the cot cover indicates the maximum
permissible height of the mattress used in this product (A, fig. 5).
6.
The cot has been correctly installed (fig. 6).

Height adjustment

To change the height of the cot, two movements are required.
1.
Lift the upper part of the height adjustment handle (1, fig. 7).
2.
Press the button on the handle.
Once the above is done, set the selected height while holding the stabilization
bar with your foot (fig. 8).
There are five cot heights available. It is also possible to set different heights on either
side. WARNING: The permissible maximum inclination of the cot is a difference
of 2 levels. The child's head must always be on the side set in a higher position.
Rocker function
To use the rocker function, move the locking handles (1, fig. 9) and then lift all
the wheels (2, fig. 9) so that they are not in contact with the ground (fig. 9). The
correct locking of the wheels in the selected position will be signalled by the
click of the locking handle.

Wheel lock

To lock the wheels, press in the locks located on each wheel (A, fig. 10). To
unlock the wheels, lift the wheel locks (B, fig. 10).
‑ 11 ‑ EN