Lionelo Bella Bedienungsanleitung Seite 15

Using the rocker
1.
The rocker can be rotated 360° in any direction (fig. 12).
2.
To change the position of the seat, press the adjustment buttons (8, fig.
A) located on both sides of the frame, and then select one of the three
positions - seated, reclining or semi-reclining (fig. 13).
3.
To start the device, connect it to the power source or insert batteries, then
press the switch on the remote control or control panel.
4.
Choose from five rocking speeds.
Rocking modes
1.
Select one of the six rocking modes (fig. 14). Selecting mode one (10, fig.
C) will change the rocking mode about every 16 seconds.
2.
Select night mode on the control panel (16, fig. C) or remote control (9,
fig. D), the device will start to slow down rocking until it stops completely.
Child motion detection
To activate the child motion detection function, press button 7 (fig. C) on the
control panel or 10 (fig. D) on the remote control. Press again to turn it off.
When the baby's motion is detected, the rocking and melody will be turned
on automatically.
Melodies
Press button 9 (fig. C) to activate one of the available melodies on the control
panel. Press the button again to turn it off. Press and hold to increase or decrease
the volume.
Press button 3 (fig. D) to select a melody using the remote control. Change the
melody to the next or previous one using buttons 4 and 5 (fig. D). Increase or
decrease the volume with buttons 6 and 7 (fig. D).
Assembling and disassembling the carrycot of the cot (applies
to Bella Set)
To mount the cot on the product frame, follow the same steps described in the
subsection Mounting the rocker. The cot can be rotated 360° in any direction.
‑ 15 ‑ EN