Seat Belts - Lionelo Bella Bedienungsanleitung

2.
Place the button battery in the tray (1, fig. F), and then place the whole in
the remote control (2, fig. F).
3.
Close the battery compartment. A click will signal a proper closure.
Assembly and disassembly of the rocker
1.
Place the rocker supports on the base (fig. 1). The correct installation will
be signalled by the click of the release buttons (B, fig. 1).
2.
Connect the front and rear parts of the frame (fig. 2). Notice the labelling
of the pipes (1, fig. 2) and connect the pipes marked with the same letter.
The correct installation will signal a click.
3.
Make sure the metal tabs are in the correct holes (2, fig. 2).
4.
Place the cover over the frame of the rocker (fig. 3). Make sure that the
cover is correctly placed (2,3 fig. 3) and the zipper is fully fastened (fig. 4,5).
Do not use the rocker if the zipper is not completely fastened (A,B, fig. 5).
5.
To remove the rocker from the base, press the release buttons (4, fig. A)
located on both sides of the mounting element (3, fig. A).

Seat belts

1.
Unbuckle the belts by pressing the button located in the buckle (2, fig. 6).
2.
Insert the belts into the appropriate holes in the cover, adjusting them to
the height of the child (fig. 7). Insert the belts into the buckles, located on
the back of the seat, and tighten (1,2,3, fig. 7).
3.
After placing the baby in the rocker, fasten the belts by inserting the latch
parts into the buckle (1, 2, fig. 8), and then fasten the hook-and-loop
fastener of the cover (3, fig. 8).
4.
The correct fastening will signal a click. Do not use the rocker if the belts
are not properly fastened (fig. 9).
Toy headband
Note! Do not carry the product while holding it by the headband.
1.
Insert the toy headband into the mounting piece located on the frame of
the rocker (fig. 10). The correct installation will signal a click. The headband
can be adjusted to five positions (fig. 11).
2.
To remove the headband from the frame of the rocker, press the release
button (12, fig. B).
EN ‑ 14 ‑