Power Supply - Lionelo Bella Bedienungsanleitung

2. Motion detection indicator
The indicator lights up when the child motion detection function is enabled.
3. Power indicator
The indicator lights up when the device is on.
4. On/off switch
5. Selection of rocking speed
Select one of the rocking speeds (1-5).
6. Remote control receiver
7. Baby motion detection on/off switch
8. Change of the rocking mode
9. Melody selection
10. Automatic mode
The mode changes about every 16 seconds.
11. – 15. Five rocking modes
16. Night mode
Activating this mode will cause the device to slow down the rocking until it
stops completely.
Remote control (fig. D)
1.
Battery compartment lid
2.
On/off switch
3.
Play or stop the melody
4.
Next melody
5.
Previous melody
6.
Increasing the volume
7.
Reducing the volume
8.
Selection of the rocking speed
9.
Change of the rocking mode
10. Baby motion detection on/off switch
11. Battery compartment

Power supply

Connect the USB cable to the power supply, and then plug the power supply
into a power outlet. Place the other end of the cable in the DC port located in
the base of the rocker (6, fig. A).
EN ‑ 12 ‑