Makita DCL282F Betriebsanleitung Seite 15

MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
After use
NOTICE:
Putting the cleaner against the wall
without any other support cause the cleaner to
fall down and be damaged.
► Fig.36
Cleaning
Cleaner body
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/paper filter
mounting area and the dust stopper.
► Fig.37
Dust bag
Wash the dust bag in soapy water when it is clogged
with dust and the cleaner power becomes weak. Dry it
out thoroughly before use. An insufficiently dried filter
may cause poor suction and shorten the service life of
the motor.
► Fig.38
NOTE: Paper filter is a throw-away type.
Troubleshooting
Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
Dust case cover does not close
NOTICE:
Do not attempt to repair cleaner by yourself.
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Dust stopper
Wipe dust off from the dust stopper.
Remove dust and dirt on the sponge part by lightly
tapping it.
► Fig.39: 1. Sponge part
Removing and installing the sponge
filter
sure to install it on the cleaner. If washed in water,
dry it up before installing. An insufficiently dried
sponge filter may shorten the service life of the motor.
To remove the sponge filter, remove the dust bag or
paper filter and then pinch and take the sponge filter
out.
► Fig.40: 1. Sponge filter
Press in the whole edge of the sponge filter against the
recessed wall inside the dust bag/paper filter mounting
area.
► Fig.41: 1. Recessed wall
Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard
wooden wall, beam or column, where the wall mount
for cordless cleaner can be firmly secured. Always be
sure that the wall mount for cordless cleaner is securely
attached before hanging the cleaner.
► Fig.42: 1. Wall mount for cordless cleaner
mount violently or hang other appliances than the
cleaner.
Area to be investigated
Is dust bag or paper filter full of dust ?
Is dust bag clogged ?
Is paper filter clogged ?
Is the battery cartridge discharged?
Is the battery cartridge discharged?
Is dust bag or paper filter set ?
15 ENGLISH
CAUTION:
After cleaning sponge filter, be
CAUTION:
Do not hang the cleaner to the wall
Empty dust bag or paper filter.
Dust down or wash the dust bag.
Replace paper filter.
Charge the battery cartridge.
Charge the battery cartridge.
Set dust bag or paper filter.
Fixing method