Troubleshooting; Cleaning; Storage; Solar Collector - Winter Storage - Steinbach Curve Originalbetriebsanleitung

Troubleshooting

Problem
The water in the pool does not heat
up.
Air bubbles escape from the
skimmer/outlet after the water
treatment system has been
activated.
Water runs out.

Cleaning

Only clean the product with a standard bathroom cleaner, clear tap water and a lint-free cloth.
Aggressive cleaning agents can damage the product. Dry the product with a lint-free cloth.

Storage

Solar collector - winter storage

At latest before the first frost, the solar collector must be drained and stored in a frost-proof place
without direct sunlight.
1. Check that the fill level of the pool is below the inlet nozzle.
Otherwise, close the inlet nozzle with a plug.
2. Completely unscrew the threaded rings
Attention! The remaining water in the hoses will run out.
3. Pull the fittings
18
Possible cause
Flow rate is too low.
Ambient temperature too low/
Not enough sunshine
Insufficient heating output
Lines or connections of the water
treatment system are leaky.
Lines or connections of the water
treatment system are leaky.
together with the lines out of the inlet and outlet.
6
on the inlet and the outlet.
2
Remedy
Make sure that all lines and
connections are tight.
Make sure that all lines are filled
with water and are not kinked or
squeezed shut.
Increase the runtime of the filter
pump during the day.
Make sure that the sun always
directly hits the top side of the solar
collector.
Cover the pool over night to
minimize heat loss.
You might need a second solar
collector for your pool.
Make sure that all lines and
connections are tight.
Make sure that the hoses and lines
are undamaged.
Check that all hose clamps
a tight fit.
Check that the sealing rings are
correctly inserted and are not brittle.
Check that the threaded rings
have a tight fit.
have
4