Aligning The Solar Collectors; First Use - Steinbach Curve Originalbetriebsanleitung

Aligning the solar collectors

Never place the product above the water level and not too close to the pool.
1. Fold the feet
1
bolt each .
7
If the feet are not yet attached, screw these by
hand with a screw
solar collector.
2. Take the free end of a foot and twist it counter-
clockwise to unlatch it.
3. Pull on the unlatched foot to set the desired
length.
4. Twist the end of the foot clockwise to latch the
foot again.
5. Adjust the length of the second foot the same
way.
6. Place the solar collector on a stable surface
and ensure that the sun hits the surface directly.
The solar collector is aligned.

First use

When using the product for the first time after its assembly, air bubbles may escape from
the inlet nozzle of the pool for a short time. If this takes longer than 2 to 3 minutes, check
the water treatment system for leaks. If no bubbles escape at all, make sure that the solar
collector is correctly installed in the water treatment system (see "Connecting the solar
collector").
1. Make sure that all water lines of the water treatment system are open.
2. Turn on the water treatment system.
Air bubbles escape from the inlet nozzle of the pool until the lines are bled.
3. Wait a few minutes until air bubbles no longer escape.
If air bubbles still escape after 2 to 3 minutes, check all connections and lines for leaks.
4. Remove the protective film on the top side of the product, if applicable.
The solar collector is ready for operation.
outward and fix them with a
and a nut each
8
4
to the
9
1
8
7
17