Troubleshooting - Steinbach 49100 Bedienungsanleitung

Initial use
Once the solar collector is assembled and the hoses are connected
to the fi lter pump and the pool, open the water supply and ensure that
water is fl owing through the hose. Then turn on the fi lter system. Air
bubbles will rise from the inlet nozzle in the pool. This happens as the
air is expelled from the solar collector. If this continues for more than 2-3
minutes, check the tightness of the connections in your system.
Please note: Cover your pool overnight to avoid loss of heat.
Trouble shooting
Problem Cause / Solution
The pool does not ■ Make sure that water is fl owing through
warm up. the hoses.
■ Has it been sunny enough?
■ Exploit the maximum amount of sunlight
and increase the running time of the fi lter
pump.
■ Cover your pool overnight to avoid loss
of heat.
■ It is possible that you may need several
solar collectors.
No bubbles appear ■ Check the fi lter system and ensure that
after the equipment has water from the pool is fl owing through the
been attached to the fi lter pump, then through the solar col-
pump. lector and fi nally through the connector
hose back to the pool.
Air bubbles come out ■ Check the connector hoses for any da-
of the pool return after mage.
the pump has been ■ Check that the hose clamps have been
turned on. properly tightened.
Water escaping. ■ Check the seals in the system of pipes.
■ Check whether you have tightened the
hose clamps tightly enough.
■ Check the connector hoses for any
cracks.
Important Note
Technichal data
■ Dimensions: : L x B x H 55 x 55 x 27 cm
■ Maximum pressure 1 bar bei 20 °C
■ Water fl ow rate max. 7.500 l/h
■ Water content collector 10 l
Product care
The solar collector should not be exposed to cold weather. The solar
collector should be stored in an area protected from frost before the fi rst
frost, or at the end of the pool season.
All parts must be rinsed or cleaned with water only. Detergents may
damage the protective cover.
Over wintering
Drain all the water from the solar collector by closing off the pipes. Store
the equipment away for winter in an area protected from frost. Remove
the pool return pipes.
Make sure there is no water left inside the equipment as this can freeze.
Water expands as it freezes and so can damage the solar chambers.
Cleaning
Use conventional cleaning products. Do not use solvent-based or abra-
sive cleaning agents/tools, i.e. no hard sponges, brushes etc..
Storage
The product must be thoroughly dried after cleaning. After which, it is to
be stored in a dry location protected from frost.
Disposal
Disposing of packaging: The packaging material has been selected
in view of environmental concerns and disposability and is therefore
recyclable. The paper and cardboard can be recycled, as can the plastic
coverings.
Disposing of the product: Applicable in the European Union and other
European states with systems in place for collecting and sorting recycla-
ble materials. Dispose of the product in accordance with any laws and
regulations applicable at your place of residence.
Warranty conditions
The respective country's legal provisions for warranty conditions shall
apply accordingly. For Austria and Germany, these apply for 2 years
after the date of invoice.
049100_v1901 EN
9