ecoQ CoolAir 16+ Benutzerhandbuch Seite 104

8. Troubleshooting
Symptom Inspection
The unit
Check the power connection in
is not
securely.
operating.
Check if the water full?
Check the room temperature.
The unit Check the air filter for dirt.
works with
Check if the air duct is blocked.
reduced
Check if a room door or window is
capacity.
open.
Check if the desired operating mode
is selected and the temperature is
properly set.
The exhaust hose is detached.
Water Overflow while moving the unit.
Leakage
Check if the drain hose is kinked or
bends.
Excessive
Check if the unit is securely
Noise
positioned.
Check if any loose, vibrating parts.
Noise sounds like water flowing.
Error E0 Communication faults between main
Codes PCB and display PCB.
E1
Ambient temperature sensor failure
E2
Coil temperature sensor failures.
Ft
Condensate water high level alarm.
102 | Owner's Manual ecoQ CoolAir 16+
Solution
Insert the power cord securely into
the wall Outlet.
Empty the drain pan by remove the
rubber plug.
The range of operating temperature is
5-35 °C.
Clean the air filter as necessary.
To clear the obstacle.
Keep the door and windows closed.
Set the mode and temperature at
proper set-point according to manual.
Make sure the exhaust hose is
securely attached.
Empty the water tank before
transport.
Straighten the hose to avoid a trap
existing.
Place the unit on horizontal and firm
ground.
Secure and tight the parts.
Noise comes from flowing refrigerant.
This is normal.
Check the wire harness of the display
PCB for damage.
Check connection or replace it. To
clean or replace the temperature
sensor.
Check connection or replace it. To
clean or replace the temperature
sensor.
Empty the drain pan by removal the
rubber plug.