Gene Ral N Otes Ab O Ut A Ss Em B Ly - S-WORKS KENEVO S Bedienungsanleitung

6. GENE RAL N OTES AB O UT A SS EM B LY

This manual is not intended as a comprehensive assembly, use, service, repair or maintenance
guide. Please see your Authorized Specialized Retailer for all service, repairs or maintenance.
Your Authorized Specialized Retailer may also be able to refer you to classes, clinics or books
on bicycle use, service, repair, and maintenance.
WARNING! Due to the complexity of the Kenevo SL bicycle, proper assembly
requires a high degree of mechanical expertise, skill, training, and specialty
tools. Therefore, it is essential for your safety that the assembly, maintenance,
and troubleshooting be performed by an Authorized Specialized Retailer.
Before your first ride, make sure your components, such as brakes and
drivetrain, are assembled and adjusted in accordance with the manufacturer's
instructions and are functioning properly.
WARNING! Many components on the Kenevo SL, including, but not limited to
the motor, battery, and cable guides, are proprietary to the Kenevo SL. Only
use originally supplied components and hardware at all times. Use of other
components or hardware will compromise the integrity and strength of the
assembly. Kenevo SL specific components should only be used on the Kenevo
SL and not on other bicycles, even if they fit. Failure to follow this warning
could result in serious injury or death.
WARNING! Never modify your frame or bicycle in any way. Do not sand,
drill, file, or remove parts from your bicycle. Do not install incompatible
components or hardware. Failure to follow this warning may result in serious
personal injury or death.
WARNING! Electrical components can be exposed when working on your
bicycle. Do not touch any part of the electrical system while under electric
charge. Do not expose the connections of the battery and frame to water. If
any live components or the battery are damaged, stop riding immediately and
bring your bicycle to your Authorized Specialized Retailer.
6 .1. HEA DS E T B EAR I NG S
The headset uses a 1 1/8" (42 mm x 30.5 x 8 mm, 45 x 45°) Campagnolo Standard
„
compatible upper bearing and a 1.5" (52 mm x 40 x 7 mm, 45 x 45°) lower bearing. Ensure
that replacement bearings are compatible with the Specialized headset specification.
No tools are needed for installation or removal of both bearings. Grease the bearing
„
surfaces before installation.
For more information on the installation of the headset bearings see section 12 in this manual.
„
WARNING! Burrs and sharp edges can damage the carbon and alloy surfaces
of the components. Any deep scratches or gouges in the stem or fork can
weaken the components.
6 .2. SEAT P OST
SEATPOST MINIMUM INSERTION:
Both the frame and seatpost have
minimum insertion requirements. In
addition, the frame has a maximum
insertion requirement to prevent damage
to the frame and seatpost.
MINIMUM INSERTION: The seatpost
„
must be inserted into the frame deep
enough so the minimum insertion/
maximum extension (min/max) mark
on the seatpost is not visible. The
frame requires a minimum of 80 mm
of insertion.
MAXIMUM INSERTION: The seat tube
„
is reamed to a specified maximum
insertion depth for each frame size.
This ream depth limits the insertion
depth of the seatpost. Please refer to
the table in Fig. 6.1.
6.1
SIZE MAX INSERTION
S2 188
S3 210
S4 229
S5 255
MAX
10