Charging Devices - Hama MagPower 5 Bedienungsanleitung

4. Operation
Note - Switching on / off
• Press the button on the power pack to switch this on, to determine the power pack's current
capacity and to start the wireless function.
• The power pack switches itself off after around 30 seconds of non-use. Press the Power button
twice to switch the power pack off manually. When the power pack switches off, the LED display
also goes out.
4.1. Charging the MagPower 5
• Start the power pack charging process by connecting the enclosed USB-C cable to the USB-C input
on the Power Pack (IN 5 V / 2 A or 9 V / 1.5 A) and to a suitable USB-C charger. To do this,
consult the operating instructions for the USB charger you are using.
• The charging process begins and ends automatically.
• Fully charge the power pack once before using it for the rst time.
Note – capacity
• During the power pack charging process, the capacity is displayed constantly.
• Each LED (4) corresponds to 25% of the capacity. The permanent illumination of an LED
indicates that the capacity has already been reached. If three LEDs light up and the fourth one
ashes, the power pack is at least 75% charged.
• If all four LEDs (4) light up, the full capacity is available.
Warning - rechargeable battery
• Do not charge the power pack via your PC or notebook. The charging currents can damage the
USB port on the PC or notebook.
• Only use suitable charging devices or USB ports to charge the product.
• Do not use defective chargers or USB ports and do not attempt to repair them.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
• When stored over a long period of time, batteries should be charged regularly (at least every
three months).

4.2. Charging devices

4.2.1. Wireless charging with the induction charging zone:
• rst switch the power pack on using the Power button (3).
• The blue function LED (2) brie y signals that the power pack is ready and then switches off
• Place your device with its back on the inductive charging zone (B).
• The "MagPower 5" power pack is compatible with Apple MagSafe technology. The correct
alignment and xation of the device takes place automatically thanks to the magnets integrated
into the power pack and the iPhone.
• All other smartphones that support the inductive charging function should also be placed on the
induction charging zone (B). In this case, however, the automatic central xing of the device does
not take place.
• The charging process begins as soon as an effective induction eld has been established. The
status LED (2) lights up blue. The current charge status is displayed on your device.
• If no induction connection can be established, change the position of your device if necessary (B).
(For all smartphones that do not feature MagSafe technology)
• If your device's battery is fully charged, the status LED (2) goes out once when you remove the
device.
3