KLASS Fan ELECTRA DC Anleitung Seite 18

2
- Select the right down rod depending
on the height of your ceiling.
- If neither of the down rods fits,
contact your fan distributor.
- Remove the screw and bolt from the
hanger ball.
- Remove the locking pin, the two
screws off the coupler.
- Place the downrod through the
coupler cover and the canopy, and
route the electrical cables through the
downrod.
- Install back the screws and bolt to
the hanger ball, ensure to fasten the
screws.
- Insert the downrod into the coupler,
insert the coupling screws and the pin,
tighten the two screws on the coupler
and close with the cover.
3
- Fix blade support to the motor
assembly and the blade on the blade
support with provided screws.
- Repeat step for all blades.
4
Hang the fan motor housing on the
mounting bracket, ensure the ball joint
locating the groove aligns with the
notch on the mounting bracket.
downrod
coupler
Motor assembly
16
screw
hanger
ball
power cord
Blade
Blade bracket
Notch
Locating
groove
pin
canopy
coupler
cover
bolt
locking pin