General Information; Disclaimer; Safety Note - behnke AT2 Anleitung

2. GENERAL INFORMATION

The device uses state-of-the-art technology and
complies with recognized current standards
on safety-related devices. These installation
instructions must be followed by all technicians
involved with the equipment, whether during
installation or maintenance. It is imperative that
these installation instructions are accessible at
all times to the responsible installers, techni-
cians, and maintenance and servicing staff. The
prerequisite for the safe handling and trou-
ble-free operation of this system is knowledge
of the basic and special safety regulations in
materials-handling technology, especially in
elevator technology.
The device may only be used as intended.
In particular, do not make any unauthorized
changes or add parts to the device or to individ-
ual components.

Disclaimer

The manufacturer shall not be liable to the pur-
chaser of this product or any third party for any
damage, loss, expense or labor caused by acci-
dent, misuse of the product, improper instal-
lation or unauthorized alterations, repairs or
additions. Warranty services are also excluded
in such cases. The manufacturer accepts no
liability for misprints, oversights or changes.
generAl informAtion

Safety note!

▸
This product may only be installed and con-
figured by appropriately trained staff who are
authorized to perform work on this device.
▸
This quality product is aimed at the elevator
industry. It has been designed and manufac-
tured for the specified use only. When used for
any other purpose, SafeLine must be notified in
advance.
▸
It must not be modified or altered in any way
and must be installed and configured in strict
accordance with the procedures described in
this manual.
▸
When installing and configuring this product,
pay close attention to all the relevant occupa-
tional safety requirements and all equipment
standards.
▸
After installation and configuration, this prod-
uct and the function of the system should be
fully tested to ensure proper operation before
the system is put into use.
▸
Requirements from national regulations may
deviate from preset values. The set parameters
must be checked and adjusted if necessary.
Electrical and electronic products may contain
materials, parts and units that can be hazard-
ous to the environment and health. Please
inform yourself about local regulations and
waste collection systems for electrical and elec-
tronic products and batteries. Proper disposal
of your old product will help prevent negative
consequences for the environment and human
health.
Behnke AT2 Manual
33