Brake Adjustment - AUTOMOBILI LAMBORGHINI AL EXT Bedienungsanleitung

Brake adjustment

AL EXT
Adjusting the brake calliper
If the brake is too tight or too loose, use the hex wrench to
loosen screw (A), then adjust the brake wire (shorten the
brake wire from the top end if it is too tight. If the wire is
too loose, pull it from the bottom end), then tighten screw
(A) again.
If the wire is too loose or too tight even after following the
first step, it may be necessary to adjust the (fixed) brake
pad by means of the wheel located on the opposite side. Use
the hex wrench to move away (counter-clockwise) or closer
(clockwise) the brake pad (B) (see picture). Check the correct
alignment between the brake caliper and the disc. Use screws
C and D to adjust the position / alignment on the disc, if
necessary.
For the rear brake calliper, unscrew and remove bolts C and D,
then remove the brake calliper from the disc.
19