Indu-Sol PROmesh B28-R Schnellstartanleitung Seite 10

IP Adresse
Subnetzmaske
Gateway
Benutzername
Passwort
After successful installation and start of the software, you can scan the system with the
search setting PROmesh B28. The PROmesh B28-R is displayed in the search result. You
can then make and save individual entries in the input mask.
! NOTE Make sure that the IP address you selected has not yet been assigned. If required, you
can display IP addresses that have already been assigned using the PROscan® Active V2
license software from Indu-Sol.
When logging in for the first time, you must change the factory-set password. It is your
! WARNING
responsibility to document this password and protect it against unauthorized access
Accessing the Web User
The device-specific functions of the PROmesh B28-R can be configured via an integra-
Interface
ted Web-UI. Open your browser, enter the IP address of the PROmesh B28-R configured
in the ServiceTool in your browser bar or use the above configuration data. Alterna-
tively, you can right-click on the corresponding list entry in the context menu of the
ServiceTool to select „to website". The Web UI now opens in your standard browser.
Further information on the configuration options and troubleshooting can be found at
! NOTE
the following link:
www.indu-sol.com/en/manual-promesh
18
192.168.1.254
255.255.255.0
0.0.0.0
admin123
admin123
ENGLISH
Restore Factory Setting
Interpreting LED Displays
RESET is restoring default settings button.Device Restoring defaultsettings steps as
follows: press and hold the RESET button, power on the device again, wait for about
3~4 seconds to restore the factory settings.
LED label Mode Meaning
PWR1 On Voltage at terminal sufficient
Off Voltage at terminal insufficient
PWR2 On Voltage at terminal sufficient
Off Voltage at terminal insufficient
Status On The system is not operating normally
Flashing The system is working correctly
Off The system does not start correctly
Alert On There is an alarm (power supply or port
connection)
Off There is no error.
Port Status On The port has established a valid network
connection
Flashing The port is in network communication exchange
Off The port has not established a valid network
connection
ENGLISH
19