Olympia PS 710.3 CCD Bedienungsanleitung Seite 23

11 Troubleshooting
Problem
Device does not
work
Device no
longer functions
after a longer
period out of
service or stops
during operation
Overloading
(material jam)
Note: If you cannot clear the fault yourself, contact your dealer or call the Olym-
pia hotline.
12 Disposal
This symbol (crossed out waste bin) indicates that the product must be
returned to an authorised recycling centre or separate collection point when
it has reached the end of its service life. The symbol only applies to states
within the EEA (*)
(*) EEA = European Economic Area, which is comprised of the member
states of the EU plus Norway, Island and Liechtenstein.
Diagnosis & Cause
Is the power plug connected
properly in the power socket?
Is the On/Off switch set to
OFF?
Is the AUTO function activated?
Has the device been assembled
properly?
Does the motor fail to start
when paper is inserted?
Was the device shutdown for a
longer time? Is the surface of
the device
permissible operating cycle has
probably been exceeded.
Have you exceeded
permissible material capacity
(refer to Chapter "Technical
Data")? Has the material been
fed in askew?
Solution
Connect the power plug to the
power socket properly.
Set the On/Off switch to its ON
position.
Press the AUTO button.
Ensure that the waste bin has
been inserted properly.
Slide
respective infeed slot so that it
makes contact with the sensor
in the middle.
First of all, disconnect the
power plug from the power
socket and allow the motor to
warm? The cool down to room temperature.
For information on the operating
cycle,
"Technical Data".
the
Clear the material jam, refer to
Chapter "Clearing a material
jam".
23
the paper in
refer to Chapter
the