Replacing The Batteries - Pepita SmileHome SFA010 Bedienungsanleitung

Programming the user code
A. With the door of the safe open, press the red button (b) (see diagram 2)(located on the inside of
the door near the hinge) and the display will show 'SET CODE'.
B. Now press any numbers reaching 3 to 8 digits that you wish to use as a new user code and
confirm by pressing the button 'START'. After hearing a musical sound, the display will show
'IN' and your given numbers. It means that the new user code is confirmed.
Programming the master code
A. Press the red button, then press the button 'START'. The display will show 'OLD CODE'.
B. Now input the original master code (factory-preset code: 8,8,8,8) and press the button 'START'.
The display will show 'SET'. Now press from 3 to 8 numbers that you wish to use as a new
master code and confirm by pressing the button 'START'. Now the display will show 'RE-
INPUT'.
C. Now enter your inputting numbers again and confirm by pressing the button 'START'. After
hearing a musical sound, the display will show 'IN' and your given numbers. It means that the
new master code is confirmed.
If you or an intruder uses the incorrect group of numbers, you will hear a beep with the display
showing 'ERROR' and it will not open. If the incorrect combination code is used 4 times
consecutively, the display will show 'Error' and the buzzer will sound for approximately 3 minutes.
The correct code cannot be entered until after this 3-minute delay. The override key can however be
used to open the door during these three minutes. If the key is used to open the door, the buzzer can
be cleared by pressing the red button(b)(see diagram 2).
5. BATTERY REPLACEMENT WARNING
To test the batteries, just press the button 'START'. If the batteries are low, the display will show
'LO-BAE', and you should replace the batteries.

6. REPLACING THE BATTERIES

The safe requires 4×size 'AA' (1.5V) batteries.
Open the safe, remove the battery cover on the back of the door, and replace the old batteries.
Use of alkaline batteries is recommended.
7. OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, we have engineered a manual override system for your safe. If you forget or
misplace your combination, the safe can be opened by the override key manually.
A. To use the key, remove the small plastic cover on the front panel.
B. Turn the key anti-clockwise, turn the knob clockwise and then turn the handle clockwise to open
the safe.
8. CLOSING THE SAFE
First, turn the handle in an anti-clockwise direction, and then turn the knob still in an anticlockwise
direction. That will close the safe.
9. INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured to floor, wall or in a cupboard. For your
convenience, there are holes (diameter 8mm) on the back and in the bottom; therefore, it can be fixed
by the expansion bolts.