Installing The Batteries - Pepita SmileHome SFA010 Bedienungsanleitung

CAUTION! Do not keep the keys in the safe itself!
1. OPENING THE SAFE FOR THE FIRST TIME
To open the safe for the first time, remove the small plastic cover (a)(see diagram 1) on the front
panel, insert the key into the lock and turn it counter-clockwise, at the same time, turn the knob
clockwise,and then turn the handle in a clockwise direction to open the safe.

2. INSTALLING THE BATTERIES

The safe requires 4×size 'AA' (1.5V) batteries. Remove the battery cover(on the back of the safe
door) and install the batteries into the compartment. Ensuring the batteries are fitted with the correct
corresponding polarity. The display will scan the status of the electronic lock system automatically.
If it is in order, the display (c) (see diagram 1) will show 'GOOD'.
Use of alkaline batteries is recommended.
3. OPENING THE SAFE AFTER INSTALLING THE BATTERIES
To open the door of the safe, press the button 'START' (d) (see diagram1), the display on the panel
will show '--------', then input one of the two sets of factory-preset codes: 0,0,0,0 (user code) or
8,8,8,8 (master code) immediately and confirm by pressing the button 'START'. You will hear a
sound with the display showing 'OPEN' and open the safe using the knob within approximately 4
seconds, and then turn the handle in a clockwise direction to open the safe.
If you do not want the display to show your codes when you open the safe, press the button 'START'
twice first and thenfollow the steps given for door opening.
4. PROGRAMMING THE CODE
NOTICE: The safe can be programmed with two sets of codes.For your safety, after opening the
safe and installing the batteries, you should program two sets of your new codes to replace the two
sets of factory-preset codes.