Troubleshooting Table - Pekatherm F70 Benutzerhandbuch

TROUBLESHOOTING TABLE

When the product is plugged in, the digital display indicator does not light.
Check whether your mains socket has power, check whether the product is plugged in
correctly. Unplug the product and wait a few seconds, then plug it in again. Push the
ON/OFF button on the control unit.
After pushing the ON/OFF button on the control unit, the control unit fails
to set at the default temperature level, and the product does not warm up.
The control unit may have found an error at the start and blocks the product operation
for safety. Check if the digital display indicator has any special flashing.
Unplug the product from the mains, wait a few seconds and plug it again. If the problem
persists, take the product to an authorized service centre.
The product does not warm up.
Make sure the product is powered, by checking whether the digital display indicator on
the control unit is lit. Make sure the product is operating, by checking whether the digital
display indicator on the control unit is set at any temperature level. Remember that the
safety AUTO-OFF function may have switched the product off if the safety time period is
over. If that's the case, push the ON/OFF button to switch the product on. In case of any
doubt, reset the product by unplugging it from the mains and plugging it in after a few
seconds.
After a period of proper functioning, the digital display indicator go off,
only digital dot remains lit on the digital display indicator, and the product
stops warming.
In order to ensure safety in use, all our products are provided with a safety AUTO-OFF
option which switches the product off after a certain number of hours of continuous
operation. The period is 2 hours for footwarmers. See SAFTEY ELEMENTS paragraph for
details.
If you want to turn on the product, just push the ON/OFF button on the controller.
The control unit appears to malfunction: the digital display indicator flash
continuously or shows strange symbols.
The control unit may have found a problem and blocks the product operation for safety.
Unplug the product from the mains, wait a few seconds and plug it in again. If the
problem persists, take the product to an authorized service centre.
19