Pekatherm F70 Benutzerhandbuch Seite 16

OPERATING INTRUCTIONS
1) Insert your feet inside the boot, unzipping the front part the product if necessary.
2) Close the zip and fasten the boot's central tab, bringing it between your legs until
the magnet inside the tab connects to the rear part of the boot.
3) Plug the product into the mains socket, making sure your main's specifications
correspond to those of the product stated of the label.
4) If everything is correct, only digital dot remains lit on the digital display indicator
on the control unit (heating function is not active yet).
5) Push the ON/OFF button on the control unit to switch on the product. Digital
display indicator shows default temperature setting.
6) Proceed to adjust the temperature among the four available settings by pushing
the temperature button on the control unit. In the same way, adjust your desired
AUTO-OFF time by pushing the time button. At this point the product is running
and regulating temperature normally. After a few minutes you will be able to
perceive warmth. Check that there are no creases or folds.
7) To switch off the product proceed to push the ON/OFF button again. The heating
element remains switched off and only digital dot is lit on the digital display.
To turn the product on push the ON/OFF button once again.
Remember to unplug the product from the mains if you do not use it for a
considerable period of time.
8) Unplug the product and let it cool down before storage.
16