Control Panel Description; First Time Use - Bauknecht BAR2 KH8V2 IN Kurzanleitung

Quick guide
THANK YOU FOR BUYING A BAUKNECHT
PRODUCT
In order to receive a more complete
assistance, please register your product on
www . bauknecht . eu/register

CONTROL PANEL DESCRIPTION

1
1. SELECTION KNOB
For switching the oven on by selecting
a function.
Turn to the position to switch the
oven off.
2. LIGHT
With the oven switched on, press to
turn the oven compartment lamp on or
off.
SLIDING RUNNERS AND SHELF GUIDES
Before using the oven remove the protective tape [a] and
then remove the protective foil [b] from the sliding runners.
REMOVING THE SLIDING RUNNERS [c]
Pull the lower part of the sliding runner to uncouple the
lower hooks (1) and pull the the sliding runners upwards,
removing them from the upper hooks (2).
REFITTING THE SLIDING RUNNERS [d]
Hook the upper hooks on the shelf guides (1) then press the
lower part of the sliding runners against the shelf guides, until

FIRST TIME USE

1. SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: press
the two digits for the hour start flashing on the display.
Use or to set the hour and press
digits for the minutes will start flashing. Use
the minutes and press
Please note: When the icon is flashing, for example following
lengthy power outages, you will need to reset the time.
2 3
3. SETTING THE TIME
For accessing the cooking time settings,
delayed start and timer. For displaying
the time when the oven is off.
4. DISPLAY
5. ADJUSTMENT BUTTONS
For changing the cooking time settings.
until the
to confirm. The two
or
to confirm.
Before using the appliance carefully read the Safety
Instruction.
4
the lower hooks are clicking (2).
2
1
REMOVING AND REFITTING THE SHELF GUIDES
1. To remove the shelf guides, firmly grip the external part of
the guide, and pull it towards you to extract the support and
the two internal pins from the lodging.
2. To reposition the shelf guides, position them near the
cavity and initially insert the two pins into their lodgings.
Next, position the external part near its lodging, insert the
support, and firmly press towards the wall of the cavity to
make sure the shelf guide is properly secured.
2. HEAT THE OVEN
A new oven may release odours that have been left behind
icon and during manufacturing: this is completely normal.
Before starting to cook food, we therefore recommend
heating the oven with it empty in order to remove any
possible odours.
Remove any protective cardboard or transparent film from
the oven and remove any accessories from inside it.
Heat the oven to 250 ° C for about one hour. The oven must
be empty during this time.
to set
Please note: It is advisable to air the room after using the appliance
for the first time.
5
6. THERMOSTAT KNOB
Turn to select the temperature you
require when activating manual
functions.
For automatic functions use .
Please note: All knobs are push-activated
knobs. Push down on the centre of the
knob to release it from its seating.
[c]
EN
6
1
2
[d]