Switching Off; Disconnecting The Water Hoses - Medion ERAZER Bedienungsanleitung

The cooling kit switches off the pump and fan automatically when the
notebook switches to standby/sleep mode or shuts down.
After the initial pairing, the cooling kit connects to the notebook
automatically when the devices are within Bluetooth range and the
Control Center is installed on the notebook.
. Switching off
 Under LIQUID COOLING SYSTEM CONTROL in the Control Center
application, click on DISCONNECT. Wait until the fan and pump stop operating.
 Press the on/off switch (1). You will know the device is switched off when all the
LEDs are off.
. Disconnecting the water hoses
When you've finished using the cooling kit, follow the instructions below to
disconnect the water hoses:
 Switch off the device by pressing the on/off switch on the cooling kit.
 Disconnect the power adapter from the back of the cooling kit and remove the
power cable from the notebook.
 Remove the quick connector from the notebook horizontally. Hold onto the
quick connector rather than pulling on the hoses.
 Check whether any liquid is leaking out around the water connections. Remove
the liquid and dry all the surfaces.
 Remove any liquid that leaks out and dry all the surfaces again.
152