Getting Started - Medion ERAZER Bedienungsanleitung

Do not use coolant to fill the cooling kit. Distilled water is
recommended.
 Check the liquid fill level in the vertical window on the side of the cooling kit.
Stop pouring in liquid once it has reached the maximum marking.
 Make sure that the cooling kit water hoses are securely connected to the
notebook before continuing.
 Hold down the on/off switch (1) for the cooling kit for five seconds. When the
LED starts flashing purple, the device is in filling mode. The pump starts working
and pumps liquid into the cooling liquid circuit.
 When the level starts to drop according to the liquid fill level indicator, slowly
refill the liquid until it is back up to around 1 cm below the maximum line.
The minimum and maximum liquid fill levels are indicated on the liquid
fill level indicator.
 Check all the connections. There should not be any drops of liquid on the
housing or the surface underneath it.
 Close up the refilling connection.
Avoid tipping the cooling kit after filling it with cooling liquid.
. Getting started
 Plug the mains cable into the socket.
 Switch on the notebook and check that Bluetooth is switched on too.
 Press the on/off switch (1) on the cooling kit. The LED display will start to flash
blue.
 Open the CONTROL CENTER application. Click on
PERFORMANCE first and then on LIQUID COOLING SYSTEM CONTROL.
 Select DEVICE and then click on CONNECT. The cooling kit connects to the
notebook via Bluetooth (the fan and water pump start working). The LED display
will light up blue.
 After five minutes, check all the connections for leaks. If there are any leaks,
switch off the cooling kit and check all the connections.
The liquid fill level drops in normal operation. Refill the cooling liquid,
ensuring the level is above the minimum marking.
DE
FR
NL
ES
IT
EN
151