Ⅵ Frequently Asked Questions; Ⅵi Mainboard Information - Kywoo3D Tycoon IDEX Benutzerhandbuch

Ⅵ
Frequently Asked Questions
Q: How to flash the firmware?
A: 1.Download the corresponding firmware file on the Kywoo official website (www.kywoo3d.com).
2. Copy the file to the SD card.
3. Insert the SD card into the machine, press and hold the reset switch on the side of the printer until it enters the home page.
Q: White screen or poor display?
A: 1.Check whether the LCD ribbon cable is loose.
2. Flash the firmware again; if the issue cannot be solved, please contact our customer support(service@kywoo3d.com).
Q: The file name is garbled and cannot be read?
A: 1. Modify the file name to a number or English format.
2. Re-slice the model file.
Q: The nozzle cannot be heated?
A: 1. Check whether the nozzle harness is loose.
2. Check whether the current temperature of the nozzle is normal; if it is abnormal, the nozzle thermistor is damaged.
3. If the current temperature is normal, the heating tube is damaged.
Q: The hotbed cannot be heated?
A: 1. Check whether the wiring harness under the heating bed is loose.
2. Check whether the current temperature of the hotbed is displayed normally; if it is abnormal, the hotbed thermistor is damaged.
3. If the current temperature is normal, the hotbed plate is damaged.
14
Ⅶ
Mainboard Information
Extruder 1 Thermistor Extruder 2 Thermistor Auto-Level
Hotbed Thermistor
Auto-Level
Y-axis End-stop
LCD Ribbon Cable
Filament Detector 2
Filament Detector 1
Shut Down after Printing
Power Detector
X2-axis End-stop
X1-axis End-stop
X2-axis Motor Extruder Motor 2 Extruder Motor 1
SD Card Slot USB Port
Power Port (+)
Power Port (-)
Hotbed Heater (+)
Hotbed Heater (-)
Extruder 1 Heater
Extruder 2 Heater
Hotend Cooling Fan
Part Cooling Fan(24V)
Z-axis Motor Y-axis Motor X1-axis Motor
15