Ⅴ Start Printing; Filament Detection Function - Kywoo3D Tycoon IDEX Benutzerhandbuch

ⅴ Start Printing
Click > Files > Printing would start once you choose a file, then the hotbed and nozzle start to heat in sequence.
During your printing process, you can click " " to pause or stop the printing, adjust printing speed, and the like.
improper, you can enter > Probe Z Offset to adjust the z-axis again).
00.00
22° 22° 48° 0%
0% 0.00m
①
X X Y Y
Z Z
Media Removed
1. Click "Print
00:01/00:35
60/60° 100%
200/200° 200/200°
0% 0m
Ghost.gcode
④
Auto-leveling Test.gcode
4. Preheating
!
When using mirror or duplication mode, users need to add raft to the model when slicing.
12
(If the height of the z-axis is found
Back Back
Auto-leveling Test.gcode Auto-leveling Test.gcode Start Print
Bird whistle-2h.gcode Bird whistle-2h.gcode
②
IDM 3DBenchy.gcode
Ghost-30min.gcode Ghost-30min.gcode
③
XYZ.gcode XYZ.gcode
2. Choose a file 3. Confirm the print
100
Speed
Probe Z Offset
100
Flow
-1.405
100
Flow1
⑤
Flow2 100
Probe Z Offset
Advance K E1
0.050
5. Printing Menu
6. Z-axis Offset
V

Filament Detection Function

When the filament accidentally disconnected or runs out during printing, the printer will make a loud buzz to alert the user, and printing would be
paused. The filament detection module is above the extruder. The user needs to use the change filament function to withdraw the original filament,
insert the new filament into the extruder, and then click Resume on the screen to continue printing.
Normally printing Filament disconnected, the printer buzzes
Resume Printing: If power is interrupted during printing, the printer will prompt whether to continue the print when the power supply
is resumed.
PRINT PAUSED
Insert fiiament
and press button
to continue
Nozzle: E1
185°/185°
The screen shows printing paused
13