Ⅲ Load The Filament; Ⅳ Adjust Z-Axis Offset - Kywoo3D Tycoon IDEX Benutzerhandbuch

Load the Filament
ⅲ
When the hotbed and the nozzles reach their set temperatures, lift the Z-axis by 5cm, and pass the filament through the filament detector, then
insert it into the extruder and the nozzle. When you see the melted filament flow out from the nozzle, the filament is successfully loaded.
*When loading the filament, please make sure the distance between the Z-axis and the hotbed is beyond 5 cm.
Tips: How to Replace the Filament?
1.Cut the old filament just above the extruder and slowly feed new filament in.
2.After the nozzle is preheated, push the old filament down a little way and withdraw it quickly, then feed the new filament in.
10
Adjust Z-axis Offset

ⅳ
Insert the storage card > click > choose Auto-leveling Test. When printing the first layer, look at how well the model attaches to the hotbed,
click > Probe Z Offset to adjust the z-axis until the model can stick to the hotbed firmly, as shown in the following picture.
00:00/00:02
Back Back
①
Auto-leveling Test.gcode Auto-leveling Test.gcode
200/200° 200/200° 60/60° 100%
Bird whistle-2h.gcode Bird whistle-2h.gcode
0% 0m
Auto-leveling Test .gcode
Ghost-30min.gcode Ghost-30min.gcode
②
XYZ.gcode XYZ.gcode
Auto-leveling Test.gcode
The nozzle is too far from the hotbed, click —
Perfect printing effect
The nozzle is too close from the hotbed, click +
Speed 100
Probe Z Offset
100
Flow
-1.405
100
Flow1
③
Flow2 100
Probe Z Offset
Advance K E1
0.050
≈0.2mm
11