Remote Control - Home Hm-Rv-A350B Bedienungsanleitung

to be unplugged and removed first.
Charging
The vacuum needs to be charged to full before first use. This first charge may take up to 6
hours.
1. Place the vacuum on a flat and dry surface within reach of a power socket.
2. Set the main switch to the I (on) position.
3. Plug the power adapter's cord into the vacuum cleaner.
4. Plug the other end of the adapter into a properly grounded mains socket.
5. The button will flash while the vacuum is charging. Once full charge is reached,
the button will glow steadily. Subsequent recharging takes 3.5 to 4.5 hours, assuming
regular use.
6. Once the battery is full, unplug the power adapter from the charging port on the
vacuum and from the wall.
Once the button begins to glow red, the vacuum needs a recharge. Charge the
vacuum after each use.
Note:
During prolonged disuse, recharge the vacuum once every 2 to 3 months to extend the
useful life of the battery pack.

Remote Control

Before using the remote control, insert its batteries.
1. On the bottom of the remote, remove the battery cover plate.
2. Remove both batteries and insert new ones (2x 1.5 V AAA). Observe the polarity
markings on the bottom of the battery compartment.
3. Replace the cover.
The procedure is the same when replacing batteries, except that old batteries must be
removed first.
If you want to use the remote control, point it to the signal receiver on the appliance. The
maximum range of signal sent from the remote control is 6 m. If obstacles are located
between the remote control and the appliance, the signal cannot be transmitted.
If you will not use the remote control for a long time, we recommend removing the
batteries. If the batteries leaked into the interior of the remote control, it could damage it.
Warning:
Never put batteries in fire, short circuit or damage them in any way. After the end of their
lifetime, discard them in environmentally friendly manner. Never dispose of batteries in
household waste. Always replace both batteries together. Do not mix rechargeable and
single-use battery types.
Preparing the Room for Cleaning
Before using the vacuum, take these steps to avoid damage to the appliance or other
property, or hazardous situations.
1. Clear the floor of all cables and small items that might entangle the vacuum.
2. Secure any free carpet edges on which the vacuum might trip and tassels it might suck
in. The vacuum is not designed to clean carpets with pile height exceeding 26 mm (1
in).
9